HomeMy WebLinkAboutORD 3044BILL No. 18
ORDINANCE No. 3044
AN ORDINANCE ENACTED BY THE CALDWELL CITY COUNCIL, AMENDING
CHAPTER 12, ARTICLES 1, 5, 7, AND 13, SO AS TO PROVIDE THAT THE
BUILDING OFFICIAL MAY REVOKE PERMITS ISSUED IN ERROR OR FOR
OTHER CAUSE, AND PROVIDING CLARITY AS TO THE DEFINITION OF A
"REGISTERED DESIGN PROFESSIONAL," AS THAT TERM. IS USED IN THE
VARIOUS INTERNATIONAL CODES ADOPTED UNDER CHAPTER 12, AND
PROVIDING FOR EXCEPTIONS WHERE PREPARATION OF CONSTRUCTION
DOCUMENTS BY A REGISTERED DESIGN PROFESSIONAL IS NOT REQUIRED;
PROVIDING FOR AN EFFECTIVE DATE; PROVIDING FOR SEVERABILITY; AND
REPEALING ALL ORDINANCES, RESOLUTIONS, ORDERS AND PARTS THEREOF
IN CONFLICT HEREWITH.
NOW,THEREFORE, BE IT ORDAINED by the Mayor and City Council of the City of
Caldwell, County of Canyon., State of Idaho:
Section 1: That Chapter 12, Article 01, Section 12-01-15, of the Caldwell City Code,
pertaining to permit requirements tinder the International Building, International Residential and
International Energy Conservation Codes, is hereby amended by the addition of a new subsection
(5), relating to the revocation of permits, as follows:
12-01-15: PERMIT REQUIREMENTS; PERMIT REVOCATION:
L5L The buildin:r official r77a revoke an ermit issued in error an
c rmit issued cin the basis of incorrect information or upon learninaf' work
which has been performed in violation of this code or ;my other law c>fthe state of
Idaho. [jpon r the holder shall _cease all work until such time that
La new hermit has been issued or written notification of reactivation of the nullified
p�e�it has been received.
Section 2: That Chapter 12, Article 01, Section 12-01-21, of the Caldwell City Code,
pertaining to amendments to the International Building, International Residential and
International Energy Conservation Codes, is hereby amended by the addition of two new
definitions, clarifying the meaning of the phrase "Registered Design Professional," and by the
enumerated amendment to IBC Section 10T regarding "Submittal Documents," as follows:
12-01-21: AMENDMENTS TO THE INTERNATIONAL BUILDING
CODE, INTERNATIONAL RESIDENTIAL CODE, AND INTER-
NATIONAL ENERGY CONSERVATION CODE:
SCANNED
PAGE - I
IBC Section 202, definition for "Registered Design Professional," is amended
to read as follows: An individual who is registered or licensed to practice their
respective design profession as defined by the statutory requirements of the
professional registration laws of the state of Idaho. For purposes of this
definition, the term "design profession" shall be limited to the practices of
architecture and engineering.
IRC Section R202, definition for "Registered Design Professional," is
amended to read as follows: An individual who is registered or licensed to
practice their respective design profession as defined by the statutory
requirements of the professional registration laws of the state of Idaho. For
purposes of this definition, the term "design profession" shall be limited to the
practices of architecture and engineering.
IBC Section 107.1. Submittal documents. Submittal documents consisting_of
construction documents, statement of special inspections, geotechnical report and
other data shall be submitted in two or more sets with each permit application.
The construction documents shall be prepared by a rggistered design professional
as defined in this code (§12-01-21). Where special conditions exist, the building
official is authorized to require additional construction documents to be prepared
by a registered design professional.
Exceptions: The following may be exempt from the requirements above
depending on the exact nature of the work, subject to the building official's
authority to require additional construction documents to be prepared by
registered design professional where special conditions exist:
1. Tenant Improvements, change in use/occupancy, and alterations
less than 1,500 square feet and not exceeding two (2) stories in height, involving. a
B, M, S1, S2, F1, and F2 occupancy classification, excluding F1 occupancies used
for the manufacturing of furniture and woodworking facilities, and occupancies
storing flammable and/or combustible materials.
2. Minor Interior non-structural remodels less than 2,500 square feet
involving a B, M, A, S1, S2, F1, F2, I, and R occupancy group.
3. Group R-3 and U occupancies not exceeding three (3) stories in
height.
4. Wood pole structures not exceeding 1000 square feet, 10' max.
Bent Spacing and/or a 10' eave height.
5. Group R dwelling units not exceeding two (2) units.
PAGE - 2
Section 2: That Chapter 12, Article 05, Section 12-05-05, of the Caldwell City Code,
pertaining to permit requirements for work governed by the Idaho State Plumbing Code, is
hereby amended by the addition of a new subsection (3), relating to the revocation of permits, as
follows:
12-05-05: PERMIT FEES; PERMIT REVOCATION:
(3) The building official may revoke any hermit issued in error, any
permit issued on the basis of incorrect information or upon learning of work
which has been performed in violation of this code or any other law of the state of
Idaho Upon revocation the permit holder shall cease all work until such time that
a new permit has been issued or written notification of reactivation of the nullified
permit has been received.
Section 3: That Chapter 12, Article 07, Section 12-07-07, of the Caldwell City Code,
pertaining to permit requirements for work governed by the National Electrical Code, is hereby
amended by the addition of a new subsection (3), relating to the revocation of permits, as
follows:
12-07-07: PERMIT FEES; PERMIT REVOCATION:
(3) The building official may revoke any permit issued in error, any
permit issued on the basis of incorrect information or upon learning of work
which has been performed in violation of this code or any other law of the state of
Idaho Upon revocation the permit holder shall cease all work until such time that
a new permit has been issued or written notification of reactivation of the nullified
permit has been received.
Section 4: That Chapter 12, Article 13, Section 12-13-02, of the Caldwell City Code,
pertaining to amendments to the International Mechanical Code and International Fuel Gas
Code, is hereby amended by the addition of two new definitions, clarifying the meaning of the
phrase "Registered Design Professional," as that phrase is used in said codes, as follows:
IMC Section 202, definition for "Registered Design Professional," is amended
to read as follows: An individual who is registered or licensed to practice their
respective desmon profession as defined by the statutory requirements of the
professional registration laws of the state of Idaho. For pumoses of this
definition the term "design profession" shall be limited to the practices of
PAGE - 3
architecture and engineering,
IMC Section 903 "Factory Built Fireplaces" add new section to read as
follows:
Section 903-4 Provisions for mitigating indoor air pollutants emitted by unvented
gas fireplaces. Unvented gas fireplaces shall not be permitted without the
installation of a supplemental whole -house ventilation strategy, which will serve
to provide a non -passive outside air source to the living space during the time of
fireplace operation. Such a strategy may be provided through the installation of an
approved air-to-air heat exchanger, or an engineered ventilation system designed
to mitigate those combustion by-products emitted by the unvented gas burning
appliance.
IFGC Section 202, definition for "Registered Design Professional," is
amended to read as follows: An individual who is registered or licensed to
practice their rejective design profession as defined by the statutory
requirements of the professional registration laws of the state of Idaho. For
purposes of this definition the term "design profession" shall be limited to the
practices of architecture and engineering.
Section 5: That Chapter 12, Article 13, Section 12-13-06, of the Caldwell City Code,
pertaining to permit requirements for work governed by the International Mechanical Code
and/or International Fuel Gas Code, is hereby amended by the addition of a new subsection (3),
relating to the revocation of permits, as follows:
12-13-06: PERMIT FEES; PERMIT REVOCATION:
(3) The building_ official may revoke any permit issued in error, any
permit issued on the basis of incorrect information or upon learning of work
which has been performed in violation of this code or any other law of the state of
Idaho Upon revocation the permit holder shall cease all work until such time that
a new permit has been issued or written notification of reactivation of the nullified
permit has been received.
Section 6: This ordinance shall be in full force and effect from and after its passage,
approval, and publication, according to law.
Section 7: This ordinance is hereby declared to be severable. If any portion of this
ordinance is declared invalid by a court of competent jurisdiction, the remaining provisions shall
PAGE - 4
continue in full force and effect and shall be read to carry out the purposes of the ordinance
before the declaration of partial invalidity.
Section 8: All ordinances, resolutions, orders and parts thereof in conflict herewith
are repealed.
PASSED BY THE COUNCIL OF THE CITY OF CALDWELL, IDAHO, this 7th
day of March, 2016.
APPROVED BV THE MAYOR OF THE CITY OF CALDWELL, IDAHO, this 7th
day of March, 201.6.
-M1y(-)r-Tj-a—rr-eTNm%-Dlas
PA G E - 5
ATTEST -
N -1
(-.'ity Clerk �Dt J
C
0
4
``�G-6'iJwnwwro
ORDINANCES OF THE CITY OF CALDWELL
NOTICE OF ADOPTION AND SUMMARY OF
ORDINANCE NO. 3044
AN ORDINANCE ENACTED BY THE CALDWELL CITY COUNCIL, AMENDING CHAPTER
12, ARTICLES 1, 5, 7, AND 13, SO AS TO PROVIDE THAT THE BUILDING OFFICIAL MAY
REVOKE PERMITS ISSUED IN ERROR OR FOR OTHER CAUSE, AND PROVIDING
CLARITY AS TO THE DEFINITION OF A "REGISTERED DESIGN PROFESSIONAL," AS
THAT TERM IS USED IN THE VARIOUS INTERNATIONAL CODES ADOPTED UNDER
CHAPTER 12, AND PROVIDING FOR EXCEPTIONS WHERE PREPARATION OF
CONSTRUCTION DOCUMENTS BY A REGISTERED DESIGN PROFESSIONAL IS NOT
REQUIRED; PROVIDING FOR AN EFFECTIVE DATE; PROVIDING FOR SEVERABILITY;
AND REPEALING ALL ORDINANCES, RESOLUTIONS, ORDERS AND PARTS THEREOF IN
CONFLICT HEREWITH.
Sections 1 through 5: Amends Chapter 12, Articles 1, 5, 7, and 13, so as to provide that the building
official may revoke permits issued under the various building codes in error or for other cause, clarifies
the definition of a "registered design professional," and provides for exceptions where preparation of
construction documents by a registered design professional is not required.
Sections 6 through 8: Provides that this ordinance shall be in full force and effect from and after its
passage, approval, and publication, according to law; provides for severability; repeals conflicting
ordinances, resolutions, and orders.
Ordinance No. 3044 provides an effective date, which shall be on the 14th day of March, 2016. Ordinance
No. 3044 was passed by the Council and approved by the Mayor on the 7th day of March, 2016. The full
text of the Ordinance is available at Caldwell City Hall, 411 Blaine Street, Caldwell, Idaho 83605. The
Mayor and City Council approved the foregoing summary on the 7th day of March, 2016, for publication
on the 14th day of March, 2016, pursuant to Idaho Code § 50-901 A.
Mayor Garret Nancolas
ATTEST: Debbie Geyer, City Clerk
STATEMENT OF LEGAL ADVISOR
I have reviewed the foregoing summary and
believe that it provides a true and complete
summary of Ordinance No. 3044 and provides
adequate notice to the public as to the contents
of such ordinance.
DATED this 7th day of March, 2016.
Mark Hilty, Attorney for City of CaldwAell�